ShadeWords Gallery About us Contact us Become a dealer Specifications Construction drawings Home Systems Careers

Introduction - The Research Behind Our Fabrics
Light vs. Dark Colors
Polyester vs. Fiberglass
Why shades?

Shadecloth Features Selector
Shadecloth Specifications
Test Reports
Shadecloth Selection Guide
Shadecloth Cleaning Instructions

Specifications for Shadecloths

Solar Shadecloths for MechoShade® and ElectroShade® systems.

3.0 Shadecloths, Films

3.1 Descriptions of Physical Properties of ThermoVeil® Shadecloths
Shadecloths shall be woven of 0.010 in. or 0.018 in. opaque, extruded, vinyl-coated polyester yarn consisting of approximately 79% reinforced vinyl and 21% polyester core yarn. The shadecloth shall be tensioned in the finishing range prior to heat setting to keep the warp ends straight, minimize or eliminate weave distortion, and keep the shadecloth flat. The fabric shall be finished with heat and pressure and be dimensionally stable. The width is the manufactured standard width; custom widths shall be available up 126 in. (320cm) wide.

3.1.2 Performance
As a shadecloth, the material shall hang flat without buckling or distortion. The edge, when trimmed, shall hang straight without raveling. The unguided shade band shall roll true and straight, without shifting sideways more than ± 1/8 in. in either direction due to warp distortion or weave design.

3.1.3 Flame Retardance
Shadecloth shall be certified by an independent laboratory to pass the Large or Small Scale Vertical Burn Requirements of the National Fire Protection Association (NFPA), FFA, State of California, and Cities of New York, Boston, and Chicago.

3.1.4 Solar Optical Properties
ThermoVeil shadecloth shall be offered as standard products. Each pattern and series shall be readily available in at least three varying degrees of density and openness to accommodate the various solar loads on each of the different exposures of a building. The shadecloth shall be woven of the same yarns, have similar weaves, and be color matched by dye lot. MechoSystems shall provide independent test data on the solar optical properties of the fabrics and MirroFilms in combination with clear and heat-absorbing glass (1/4 in. single glazed and 1 in. insulated glass) and twin-glazed insulated glass. Attached are the required solar optical properties in conjunction with clear, blue-green, and bronze glass.

3.1.5 Toxicity
New York State / University of Pittsburgh Toxicity Test LC50 — 22.5 grams.
Note: LC50 of wood — 19.7g, wool — 6.4g when burning.
The lower the LC50, the more toxic the material when burning. The higher the LC50, the less toxic when burning.

3.2 Description of Physical Properties of MirroFilm Polyester Film, Reflective and/or Tinted (provided by MechoSystems)
Constructed of a sandwich of two clear or tinted polyester films with the inside face deposited with a molecular thickness of aluminum. MirroFilm shall be metalized and/or tinted as required. (See sample for specific solar optical properties.) MirroFilm can be used as an independent material or in conjunction with ThermoVeil shadecloth to achieve the desired degree of solar protection and visual transmission.

3.4 DualShade® SnapLoc® Mounting System (See also Hardware Accessories)
DualShade® by MechoSystems is the patented system for mounting ThermoVeil shadecloth and MirroFilms to the same roller by means of a snap-on fastener. The shadecloth and film shall be separated by a 1/2 in. end separator, which shall create a second stagnant air space between the window and the room air.

3.5 Color
Specifications (including colors) subject to change without notice. Other widths might be available on special order. Minimums and lead times apply.